Eastman 41066 Ss Washing Machine Hose with 90-Degree Elbow, 3/4-Inch X 3/4-Inch, 1-Pair
Eastman 2-pack 6′ stainless steel washing machine connector feature a PVC core, multi-filament braided nylon reinforcement, a clear vinyl outer shell, and a grade 304 stainless steel braided exterior that is designed to prevent kinking and crimping. The hoses include a 90° elbow for tight spaces. The washing machine connectors resist corrosion and are easy to install.
Product Features
- 6′ Length – Pair
- One 90-Degree elbow on each hose
- 3/8″ Stainless steel braided full flow high pressure hose
- Nickel plated brass nut with stainless steel ferrule
- Working temp 15F to 158F
- Hose washers included
Water hammering Causes water hammering with my high-efficiency, front-loading washer (LG). Quality craftsmanship, though.Out of curiosity, I lowered the water pressure for the entire house down to 48 PSI (from 60 PSI), but that didn’t make too much of a difference. I replaced these hoses with straight hoses that don’t have an elbow (ASIN: B00UH2SZLC) and it significantly reduced the water hammering. I plan to also add some water-hammering arresters (ASIN: B000H5MQNM) for good measure, since they’re…
Leaked after 3 months! Leaked after 3 months! This is a replacement set of same. Rating 3 stars for the right angle feature and the 5′ length. Hoping first set was a manufacturers defect. Began leaking from the inside of the 90 degree fitting and not around the washer ring where it attaches to the back of the washer port. Slow drip at first was undetected yet stained floor underneath washer with rust stain of brass deposits which were also evident running down the back of the entire washer. Leak got…
Easy change with hand tools and only takes a few … If you own a washing machine with rubber hoses and you came across these, you came to the right place. My local Home Depot didn’t have stock on these, so I found them on amazon, cheaper and with prime shipping (and in stock too!). Replace your old rubber hoses before they burst! I replaced other stainless hoses that did not have the 90 degree connectors on them in fear that the kinked hoses behind the washer pressing against the wall would one day fail. Easy change with hand tools and only…